LTE CAT-M1 Banner

LTE910XF v20.00 CAT-M1/NB2
Embedded Cellular Socket ModemLTe910XF v20

The LTE910XF v20.00 CAT-M1/NB2 Socket Modem uses the Telit ME910G1-WW as its cellular engine and has global PTCRB, AT&T, Verizon and RED certifications. The LTE910XF v20.00 units operate in CAT-M1/NB2 LTE 4G and 2G bands (see below under Features).

Verizon Mandatory FOTA Requirements App Note

The full XF line shares the Industry Standard 20-pin connector footprint and is flexible in implementation - both into new product designs and with existing products.

LTE910XF v20.00 Features

  • Form Factor
    • Industry Standard 20-Pin Connector Interface
    • PCB Mount
    • 1.14" x 1.3" x 0.256"
  • Approvals
    • Regulatory: FCC, ISED, PTCRB
    • Carrier: PTCRB, AT&T, Verizon and RED certifications
  • Temp Range: -40°C to 85°C
  • Input Voltage: 3.5 to 5.5Vdc
  • Data Rate:
    LTE Cat M1 (Rel. 14)
    • Uplink up to 1 Mbps
    • Downlink up to 588 Kbps
    LTE Cat NB2 (Rel. 14)
    • Uplink up to 160 Kbps
    • Downlink up to 120 Kbps
    EGPRS (2G Fallback variants)
    • Uplink up to 210 Kbps
    • Downlink up to 264 Kbps
  • V20.00 Frequency bands
    • LTE 4G Bands: B1 B2 B3 B4 B5 B8 B12 B13 B18 B19 B20 B25 B26 B27 B28 B66 B7
    • LTE 2G Bands: B2 B3 B5 B8
  • Interface:
    • UART & USB
    • Inernal TCP/IP stack available via AT commands
    • Use external stack with CDC-ACM and ECM drivers.
    • Supports RmNet for commands only (no data).
  • SIM Card: 3FF Micro
  • Antenna Connections: Cellular and GPS
  • Warranty: One year standard
  • Telit OneEdge™ Technology

Telit Documentation

For current Telit modules and information, visit:

Telit Module Information

Tech Support


Not sure which CF product is right for your application? Check out the CF product comparison.View XF Plug-In Comparison

Technical Support


Tech Support

New Janus Forum!

View FAQ's or ask questions over the HSPA910XF on our Janus Forum - Click here

Technical Support